Learn how to service your old scraper tractor with this helpful checklist

massey tracThe Massey Ferguson 135 is a popular choice for yard scraping duties and is often affectionately thought of as a dedicated old stalwart, seldom hitched to anything else.


Not wishing to teach anyone’s grandmother to suck eggs (as it were), here we highlight a few pointers that could help you ensure the little beauty runs without fail over the winter ahead


 






Electrics


To ensure the electrics are all kept powered it is advised to check the tension on the dynamo belt. It should be tight enough that it can only be twisted about a quarter of a turn at 90° to the running direction.


To help with engine starting in difficult conditions it is a good idea to clean the battery terminals and to ensure they are tight. The best method to clean them is simply to pour some boiling water over them and to keep them that way apply a touch of Vaseline for sealant.


Another problematic area can be around the starter motor terminals, ensure frayed wires are replaced and a good, clean connection is in place.


The heated start system can be temperamental and is usually a result of the glow plugs being worn out. Replacement is simple enough and should solve any issues, but first it’s a good idea to test the circuit with a phase tester to see if the glow plug feed is working.







massey11Brakes


Although usually out of action, brakes are handy on a yard scraper tractor. Inside the rear wheel hub you will find a slot that provides access to the brake adjuster. Using a flat-bladed screwdriver, turn the adjuster from left to right to tighten the brakes up.


 






Clutch


The clutch pedal should have an inch of free travel before the first stage bites – the second stage cuts drive to the pto – use the pinch bolt where the pedal meets the shaft to adjust the travel.






Front axle


Jacking the front of the tractor up means a few checks can be performed around the front axle and wheels. Shaking the front wheels – top to bottom – will highlight wheel bearing wear. The front axle pivot pin should also be greased regularly.


 






King pins


Track rod ends and king pins should be full of grease, this may require a new grease nipple being fitted if the originals have become damaged.


 






Air Filter


Simple and straightforward – the air filter should be checked and cleaned regularly. A simple operation that takes two minutes, it’s easily neglected.


 






Back-end


Check the back end for oil and likewise the transmission. A simple top-up may prevent a costly back end rebuild. Pressure-wash the muck off to make sure nothing is seized on the linkage and that it is all properly greased.


 






Steering


The steering box worm-drive gets worn, which can lead to wayward steering. This is a strip and rebuild job, but it is still a good idea to check the tension of the bolt [1] and the condition of the ball joint [2].



  • If you wish to get rid of the scrapper and upgrade your tractor, why not visit our classified section


 


Related links:


Want to find out how much your tractor's worth?

Our new tool will provide you with an instant valuation of any tractor in our database. This feature is in testing phase and we'd like to get your feedback.
Value my tractor